HERE’S HOW TO PREPARE YOUR QUILT FOR LONGARM QUILTING!

adapted from original article By Karen Walker on April 5, 2014 --

(to view the original article visit -Craftsy)

Once your quilt top is done, there are a few steps to take to help produce the best possible results. Most importantly, be sure to communicate with your longarm quilter to see if she has any preferences for how you should prepare above and beyond the things I tell you here!

PREPARING THE QUILT TOP

Once the quilt top is made, look to see if there are seams around the outer edges. If so, baste through these seams about 1/8″ in from the edge.

This will ensure the seams don’t pop open when loaded onto the longarm. The binding will eventually cover up these basting stitches too. You may have to baste around the entire quilt if there are multiple seams or just baste through each seam if there are only a few.

CLIPPING THREADS

If the quilt top has a light fabric that might easily show loose threads from the underside, clip those threads. No one wants to see a red thread underneath a nicely quilted area on the quilt top. Some fabrics seem to fray a lot. If you find this is the case, a small dot of Fray Check will help curb those unruly threads!

Make sure your quilt top is squared and even on all four sides. Otherwise, it cannot be loaded onto the longarm. Press the quilt top and fold neatly.

BATTING CHOICE

Ask yourself how your quilt will be used. Do you want the quilting to show or simply hold the quilt together? The batting choice can make a difference, and a good quality batting is very important.

A loftier batting will show off the quilting more than a dense batting. Comparing Hobbs 80/20 batting to 100% Warm and Natural batting, both appear to be the same thickness; however, there is a difference in the loftiness and/or density. Hobbs provides more loft and enhances the quilting. Wool batting is also a great choice for showing off the quilting. A double layer of Hobbs 80/20 and wool can give extra prominence to the quilted areas.

Be sure to check with your longarm quilter to determine the best batting choice, and also see our post on how to choose quilt batting.  (We offer a full range of quality batting.)

PREPARING THE BACKING FOR LONGARM QUILTING

You can choose to purchase an extra wide backing fabric, measuring up to 110”, or you could try piecing the back together.

Most of us quilters piece our quilt backs. The backing can be as simple as an extra strip sewn to one side or pieced together with a few unused quilt blocks or a variety of leftover fabrics. Stitch 5/8” seams when piecing the back and press them open. This helps spread the bulk.

The quilt back should measure approximately 10" larger than the quilt top. Ask your longarmer what measurements she prefers. Square up the backing on all four sides. Press the backing and fold neatly.

ONE NOTE OF CAUTION WHEN PIECING THE QUILT BACK…

Stay away from creating a symmetrical look. This can be problematic for the longarmer, as she may not be able to see the back while quilting, making it difficult to guarantee symmetry especially if the backing fabric stretches a bit. So, make fun backs with random placement of fabrics!

 

for your convenience we offer:

Batting

Wide Backs

Piecing of your backing if needed.